|
|
| WEC Series Toroidal Conductivity Controller from Walchem |
 Walchem's WEC Series Controller is a dual input/output unit designed to measure solution conductivity via an encapsulated, non-contacting (toroidal) sensor to control chemical feed pumps and alarms, and to increase system productivity. The WEC may be applied in a number of very harsh chemical applications, including oily cleaner baths, chromates, rinse tanks, fume scrubbers and other concentrated chemicals up to 1000 mS/cm. Choice of simple ON/OFF control scheme or time proportional control. UL/CS/CE certified.
-
Single or dual input: one unit monitors two baths with control output and alarm relay for each - huge savings of cost, space, installation expenses.
-
Electrodeless sensor design measure accurately over a wide dynamic range and can be used in applications from 50 µS to 1000 mS.
-
Use a low cost CPVC sensor for most applications, or a PEEK/316SS sensor for temperatures over 180°F.
-
Programmable for simple on/off control, or for time proportional control, which allows tight control of the conductivity using low cost pumps or valves.
-
Choice of conductivity measurement units: µS/cm, mS/cm, ppm or % concentration.
Microprocessor based, with easy to operate menus.
|
|
