Flow range: 0.1 to 3400 mL/min (up to 54 GPH)

Washdown for industrial process applications

IP66 and NEMA 4X rated. Electropolished 316 SS housing is protected from dust, water, and most chemical attacks.

Ideal for metering applications in process and washdown environments, including pharmaceutical, food & beverage, chemical, and water treatment

Brushless, reversible motor is quiet, efficient, maintenance-free, and easy to install

Precise PWM speed control for ±0.25% accuracy

Membrane keypad for easy programming

Calibrate system to maximize display accuracy

Remote control for integration into automated processes

Five-digit LED display

Display flow/volume in English or metric units

Protected power switch located onback of drive

Lighted display indicates power is on

Simple programming of the followingvia sealed membrane keypad:
- TUBING SELECT FLOW rate
- Motor DIRection TOTAL VOLUME
- DISPense MODE
- START/STOP Up/Down
- CALibration PRIME UNITS (English or metric)
- DISPense (vol/copy/interval)
Note: Up/Down keys are used to change the display value of flow rate and calibration functions during setup and operation.

Mount pump head(s) and load tubing.

Turn power on and select tubing size.

Select manual or remote MODE.

Select motor DIRection.

PRIME and CALibrate pump if required.

Set flow rate with Up/Down keys.

Press START key to begin pumping.

Regulate motor with Up/Down keys, 4 to 20 mA, or 0 to 10 V signal

Soft-start for starts without power surges

Speed not affected by variations in power line voltage (VAC) or frequency (Hz)

Line filters reduce outside interference

Meets UL 508C, CSA C22.2, No. 14, EN61010-1 and EN61326-1 (for CE mark)

Speed control input: 0 to 20 mA, 4 to 20 mA, and 0 to 10 V (scaleable)

START/STOP, CW/CCW, PRIME via contact closure

±0.5% linearity control

±0.50 V common mode range

18-pin circular waterproof connection

Handheld remote and foot switch options